Bush removal 820 Flexi

1350 Views 4 Replies 4 Participants Last post by cnd, Jul 21, 2014

drylandwa

Discussion Starter · Jul 19, 2014

I would like to know the best way to remove the pivot bushings on the tandem wheels (Part Nos 3498) of an 820 Flexicoil Bar. I have tried various means of extraction including hydraulic pullers to push them out and have had to resort to cutting them out with gas. This is very difficult to do without causing damage to the housing. Am I missing something?

Save

1 - 1 of 5 Posts

wafarmer75

· #2 · Jul 20, 2014

Bugger of a job no matter which way you go about it we did ours with a die grinder buy grinding one side if the bush,was a little time cosuming but less damage to the housing. Note the die in the grinder needs to be a good quality one.
Good luck

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.