The Combine Forum banner

calibrating case/ih 3152 draper on a 8010

5K views 4 replies 4 participants last post by  lanwickum 
At the combine clinic I went to we went over header calibration for the new headers rather well. He said the biggest problem is that the sensor can be out of range. It needs to be between X and Y%. I don't renumber the numbers. Basicly, loosen the sensor and turn it to be in the middle of its mechanical range for header movement. Then the monitor will allow it to calibrate.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top