The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I have a new case/ih 35ft 3152 draper on a 2007 8010, and I can't get the ground height to calibrate. It keeps telling me that all the sensors are mechanical out of range. Has anyone had this problem and how do you solve it?
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
I got it to calibrate, had to re-calibrate the feeder and I alse re-calibrated the lateral tilt. Then I did the normal ground height cal and it worked. The pro 600 did recognize the new header. Still trying to fine tune belt speed and angle of header, only cut one load so far, grain sorghum is too green, 18.3% moisture. Will try again Wed or Thur.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top