The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
412 Posts
Discussion Starter · #1 ·
I have a J&M 750 grain cart. This year we put it on a smaller tractor with smaller tires since we are getting a larger cart for the other tractor. Can the tang hitch be flipped over to level the cart up a bit since it sits a bit nose down? Will it affect the scale? Didn't know if anyone had done this. It's got a single bolt through the hitch that attaches it to the weighbar.
 

·
Registered
Joined
·
412 Posts
Discussion Starter · #4 ·
I looked through the book and it didn't say anything about which way to actually position the hitch, just stated that the weigh bar be positioned right. We ran it on a tractor with 50" rubber and it leaned forward a bit, now it's on one with 46" rubber and it leans forward quite a bit more. Figured if it could be switch it would sit more level, and it would get the auger a few more inches above the sides of the trucks.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top