The Combine Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Hey guys, just wondering if anybody had some input into which setup would work better for straight cutting canola? We have a 9770 and a t 670 and either a 635f or a 635fd without a pea auger.We do have a set of small wire conclaves for the 9770 and kinda on the fence about side knives or rotoshears.
 

·
Ooohhh Deere
Joined
·
1,940 Posts
I would go with the 670 since you have that option. Rotarys tend to put bits of green stem, pod and other stuff in the sample, sometimes making it hard to meet trash level requirements.
Use the 635F if it has a cross auger. If none do, go buy one with that $5k you just saved from vertical knives.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top