The Combine Forum banner

Case 8010 Rims

4480 Views 9 Replies 10 Participants Last post by  kylebarrington
Case 8010 dual rims cracking between stud holes, mainly inside rim on either side, any other operators having problems. What have you done to overcome problem.
1 - 1 of 10 Posts
Machinery Link is having the same problem with the JD's. A local machine shop here is cutting out the center and replacing it with a heavier ring. I believe the new one's they are putting in are 3/4 inch thick. If you do this make sure you have a competent welder do the repair. You don't want a bad weld in this area.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.