The Combine Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,
I'm having trouble with the bin clutches on a new to use ADX2230. I have constant power to the plug of each of the actuators for the sprag clutches whether the switches are turned on or off on the switch control box. There is no issue with the master clutch and the control box recognises that the bin clutches are either on or off. Previous owner disconnected the Air velocity sensors and the Bin Level Sonar but never had a problem with turning the bin on and off individually. I'm having trouble getting information out of out local flexicoil and case dealer. Any information at all would be greatly appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top