The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
998 Posts
Discussion Starter · #1 ·
2009 build 6088. Just wondering if anyone had any idea why the dead zone calibration will not perform
All pre-requisites are done and system will engage steering - just won't calibrate. Relative info would be great. Thanks
 

·
Registered
Joined
·
560 Posts
Re: Case IH AccuGuide Calibrations on new 88 serie

what software in the display, navII, and receiver?

what happens when you try to do the DZ cal? Do you get any error messages or faults?
 

·
Registered
Joined
·
998 Posts
Discussion Starter · #3 ·
Re: Case IH AccuGuide Calibrations on new 88 serie

Not sure on software - i do know that it is all of the latest and they are all compatible. When I go to do the dz cal it goes into cal mode but no reaction in the steer. The progress bar gets about half way and then it comes up with a warning - dead zone could not calibrate no steer. It is not a logged fault, nor does it have a code. Tried it a bunch of times 1st gear, hi-idle, oil warm, 1.7km/h.
After I couldn't get it to cal I did actually try to engage the steer to see if it even worked. A-B line and engaged and it worked - but not very well. I still need to do the dz and roll cal.
 
1 - 3 of 3 Posts
Top