The Combine Forum banner

Chaffer adjustment conversion

1341 Views 1 Reply 1 Participant Last post by  thegr8one
I am putting the chaffer adjustment conversion on my 9500 JD. I am to the point that i need to drill the hole this is where the problem comes i the adjuster lines up with the oval slotted hole you see of to the left in the attached pic. I am assuming this is a pic being installed on a 9600, the conversion kits are the same for the 9500 & the 9600. Any suggestions



See less See more
1 - 2 of 2 Posts
Had a typo this may make more sense. I fixed the typo in the first post.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.