The Combine Forum banner

changing viens

4249 Views 13 Replies 8 Participants Last post by  wamag
what is the easiest or least difficult way to change rotor viens. reached up in there today and it feels like they are bent over so i guess i'll change them.
1 - 2 of 14 Posts
clean the machine up really well and have a water hose close just in case and use a torch to cut the nuts and bolt out if you don't want to go through all of the work removing the rotor and feeder. I have done it that way and it works good and fast.
I use a pencil magnet and put through the hole to help the bolt through, but if that seal is leaking then you will have to pull the rotor, or fill i up with synthetic oil. it costs alot more but it will get you by.
1 - 2 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.