The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
06 model new to me....was cutting about 3rd day of wheat harvest and notice that the left side of reel is completely leaked down...was not leaking oil, just leaked down itself...tried bleeding air from little screw and messed up rubber washer...2 rubber washers later and still no change...anybody ever had this happen? i just watch it and raise it up ever so often but thats aggrivating. IH tech said it may be the master cyl....that makes no sense to me but im no tech.
 

·
Registered
Joined
·
80 Posts
Discussion Starter #3
Re: CIH 1020 30ft. slave cyl on reel lift leaks do

ok...i assume you can rebuild these...will check w/ parts counter
 

·
Registered
Joined
·
2,233 Posts
Re: CIH 1020 30ft. slave cyl on reel lift leaks do

been there done it yesterday, what a pain, service manual said master cyl, swapped cylinder same thing, removed hyd line to slave cylinder put hyd pressure gauge on line, would go up to three thousand psi and drop to nothing, lines on this head are inside tube, pulled line out and had a pin hole in line, also did you raise head and have someone hold raise button and bleed, have to have air out of system, scott.
 

·
Registered
Joined
·
80 Posts
Discussion Starter #5
Re: CIH 1020 30ft. slave cyl on reel lift leaks do

scott,
seems we have alot of the same trouble...i tried bleeding it...hence the messed up rubber washers...will check for leaks...might just have not got the air out of system...thanks again.
 
1 - 5 of 5 Posts
Top