The Combine Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
1,618 Posts
Discussion Starter · #1 ·
I stopped to fuel up my 4430 everything was working fine, then when I went to start it, it would crank over but no fire.. Loosened bleed screw on the (fuel canister) right side of engine and no fuel was coming when I was cranking?? Why?

Fuses all good..

Anybody else have this problem?
 

· Premium Member
Joined
·
8,229 Posts
They take a while to prime. That happened to me once where it ran out of fuel after I shut it off at the fuel tank. Lots of pushing that little overhead priming bulb! Rogator has the priming pump at foot level on the engine but I hope I never have to use it.:wink:
 

· Registered
Joined
·
561 Posts
Check to see you haven't inadvertently bumped the emergency shutdown switch on the panel down at the fill station. Engine will turn over but not start. You should also get a "engine controller offline" warning in your cornerpost display though.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top