The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
180 Posts
Discussion Starter · #1 ·
Is any one running a Claas chopper with cruise pilot. I know it was referred to in the owners manual but did not show up on the Cebis. Claas company gurus were here yesterday for a ride along and asked them about it. Found out it is an extra cost option, don't think the salesman knew that when we ordered the machine.
 

·
Premium Member
Joined
·
249 Posts
Is any one running a Claas chopper with cruise pilot. I know it was referred to in the owners manual but did not show up on the Cebis. Claas company gurus were here yesterday for a ride along and asked them about it. Found out it is an extra cost option, don't think the salesman knew that when we ordered the machine.
everything can be added for $$$. Rock stop, cruise pilot, etc.
 

·
Registered
Joined
·
180 Posts
Discussion Starter · #3 ·
Dealer unlocked the cruise pilot on the 880 Friday, got to try it yesterday. Set to react to engine rpms it does a good job of controlling speed. Only time it really lugged the engine was when you chopped over a dry knob and then hit some really tall green corn, but the 880 has the torque to pull through till the machine slowed down.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top