The Combine Forum banner
1 - 3 of 3 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
We run Claas Lexion 460 ( 320 hp, MB engine) with 7.5 meter header. While cutting more fertile rape or barley we noticed that engine load while trying to maintain 4.5 kph speed stuck to 100% for most of the time. Should we ignore this and keep going or is it better to lower speed of combine to maintain less load on the engine?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.