The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
439 Posts
Discussion Starter #1
Going to replace elevator and looking at changing sprockets for R66. Got 1 from Shoup before this pandemic and then I was looking at A&I sprockets. First off, A&I say made in China and they are not chromed like the Shoup one. They are cheaper cost wise for sure. Should I be concerned at all?

while I’m in there likely will change bearings too. Also how long should the clean grain auger last. Still good thickness but a little rounded on outside edge.
 

·
Registered
Joined
·
1,522 Posts
Made in china says it all , after what China is doing to Australia there is a resistance building in buying Chinese products. Fu-k Them.
If your bearings are Pfafnir and are good and you can get them off I'd leave them unless you can find US made Pfafnir bearings
 
1 - 3 of 3 Posts
Top