The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
247 Posts
Discussion Starter · #1 ·
Was looking over machines today and noticed on the 2588 that the concave hanger support plate (the concaves bolt to it on the left side) is not parallel to the angle iron that forms the bottom of the top of the cage. How's that for a complicated sentence?!! Anyhow, its nearly 1/2" lower on the front than the rear. I'm thinking that it should be parallel otherwise the concaves aren't parallel to the rotor. Yes or no?
 

·
Registered
Joined
·
998 Posts
Concave should be level with rotor front to rear yes. Don't go by looking at the hanger compared to cage - check it at the concaves. Also check the rotor to concave pinch point. On one piece concave from memory it should pinch on the 12 / 13 bar (someone may be able to correct me on that).
 
1 - 2 of 2 Posts
Top