Contour Master 9670
1 - 5 of 5 Posts
faster or slower
Faster...much....much faster...
It cant be changed in the controler. you will have to remove the orfices from the valve block and drill them out. Its the only way to do it at this time and it sucks.
It is in operators manual
-push header button 1 time is manual header lift or down adjust
-push button 2 times is AHC sensitivity adjust
-push button 3 times is C/M sensitivity
-these adjustments are same as dials in 60 series under armrest
-if still not satisfactory than yes you can adjust address in controller to further fine tune ( adjusting dead band will do wonders)
-push header button 1 time is manual header lift or down adjust
-push button 2 times is AHC sensitivity adjust
-push button 3 times is C/M sensitivity
-these adjustments are same as dials in 60 series under armrest
-if still not satisfactory than yes you can adjust address in controller to further fine tune ( adjusting dead band will do wonders)
1 - 5 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Combine Forum
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
Join now to ask and comment!
