The Combine Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
I have a client with a CR 9080 working in the field. The Unloading auger is very squeaky when it swings out. Has anyone had this issue?
 

·
Registered
Joined
·
28 Posts
Discussion Starter · #2 ·
There are no grease nipples located on the pivot, it appears to be a sealed unit. Maybe I will have to pull it off and have a look.
 

·
Registered
Joined
·
172 Posts
maybe lack of grease on the swivel of the auger??? or in the eyes of the ram?? we have had similar problems with the throat pivots, just not enough grease.
 

·
Registered
Joined
·
172 Posts
yea i think from memory there is a ring around the swivel, if you could lift it a bit you might be able to get enough in, i am doing a PDI on a CR9080 Elevation at the moment so i will check it out on my one tomorrow
 

·
Registered
Joined
·
28 Posts
Discussion Starter · #5 ·
Found problem to be dust getting in the nylon bush of the pivot area. No real fix.
 
1 - 5 of 5 Posts
Top