The Combine Forum banner
Cancel

cx top sieve

2080 Views 9 Replies 6 Participants Last post by  magspec, 
P
monitor says top sive out of position , and the line is not connected to upper sieve where to start looking ?? any help appreciated ,
Reply
Save
Like
1 - 1 of 10 Posts
crking
Sieve out of position is an alarm (not an error) telling the operator that the seive is +/- 1mm out of set position. Check the seive linkage for wear/tightness. Try to recalibrate seive.

Thought there was a software update for this issue?
Reply
Save
Like
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Combine Forum
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
John Deere Tractors Planting & Tillage Case IH Crop Production
Top