The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
Hello,

Does anyone have experience with taking off and or taking apart the cylinder drive pulley on the right hand side of the combine, I need to replace the grease fitting hose for the main cylinder bearing and I need to remove the pulley to get behind there. Any helpful hints will be appreciated!!
 

·
Registered
Joined
·
26 Posts
Discussion Starter · #4 ·
Thanks Guys!!

It is the cylinder sheave I need to take off. Hey Twopop, do I need a puller to pull the sheave off or will it come off after taking the nut off? I can see it will be heavy as hell, but think I can get grease line on if I can just move sheave out enough to get hand and wrench in there.

thanks again
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top