The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter #1
While taking the filler plates out of a 9400 I found a problem. On the far right cylinder web the weld for the hub was broke. This hub however is not connected to the cylinder shaft, it just floats on it. I re-welded it in its proper location but I'm puzzled as to why this happened. Any input would be appreciated.
 

·
Registered
Joined
·
7 Posts
I have seen it on my 9410 and my 9500 I just welded it up and it is still rinning with no probleme.I think it is n rok or something that went threw.On my 9500 i found that one of the beater plates holes broke of from that plat.
 

·
Registered
Joined
·
163 Posts
We had 3 9600's ( back in 1994 I think) that we replaced hubs in. Most broke around welds. I remember the first time it happened, still had all the cylinder speed with no spinning cylinder!
 
1 - 4 of 4 Posts
Top