The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 ·
We demoed a seed hawk 66' 12" spacing with twin wing openers. Look like it had good depth control on the seed but some of the fert was on top not sure what causes this as most of it is 2" deep in the middle. Pressure was around 900psi but fluctuated a lot.
 

·
Registered
Joined
·
497 Posts
Twin wing openers will push the fert out of its trench, we had twin wings on ours and we couldn't figure it out until I rode one the frame and watched what was happening, single knife openers do not push the fert out.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top