The Combine Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter · #1 ·
Putting a set of tridekons on a 4940 have the switch mounting down on the side console but am wondering where guys have been both pulling their power from in there and then how you are routing the wire out of the cab. Suppose I can puzzle it out but am tired after mounting the **** things and being lazy.

thanks for any replies.
 

·
Ken Adams
Joined
·
1,357 Posts
I have a foam marker that I do not use, so just tied into one of solenoids on marker and use marker switch to raise and lower dividers.
If you do not have a foamer, maybe wiring is in place for one and you could use that.
If you are using your foamer then this is of no help to you.
 

·
Registered
Joined
·
449 Posts
I purchased a factory jd toggle switch that fits into the rh counsel. This was on a 4830. Took power off spade in power block rh side cab lower front corner of counsel. Ran wire out to tridekon solenoid through lower rh corner of cab along with other factory wiring.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top