[Bwing96]

NH SP240F sprayer with Raven Envizio from factory. Dealer added Trimble auto steer with FM750. Guidance works as it should but now the Raven will loose GPS when you Start moving. Tried getting GPS to the Raven from the FM750 and from the Nav controller and both had the same results. Can spray manually but can't use the accuboom feature for automatic shut off.

What am I missing to make this work?

 

[redline73]

Do you have the autoboom unlocked in your envizio? Make sure the monitor has all the unlocks. I have no pointers when it comes to the raven losing gps signal.

 

[Bwing96]

Raven

That I'm not sure of. It acquires the same number of satellites and locks on as long as you aren't moving.

 

[redline73]

What kind of antenna are you using?

 

[Bwing96]

Ag 25

 

[cumminsman1991]

What settings are you using to output GPS. NEMA Strings? Baud Rate? ETC... Since the Envizo is not hooked up to raven autosteer it should work just fine.

Also one thisng to keep in mind is if you are using sectional control on the Envizio and are taking GPS from the nav that the nav signal is already corrected for offset measurements.

Antenna to Axle Off set, Antenna Height ETC...

So when you are setting up you off set measurement for the sectional control on the envizio take that into account.

 

[Bwing96]

Envizio says Accuboom node not detected. Where is it located? I see the single product node and boom speed node. I'm not sure if all the hardware is in place for accuboom.

 

[farmallman1949]

It sounds like you need the accuboom module that is a separate component from the envizo. On the Co-ops Case IH machine they run a Viper pro with accuboom and there is a separate control module mounted in the cab for the accuboom.

 

[Bwing96]

No DGPS

Envizio says Accuboom node not detected. Where is it located? I see the single product node and boom speed node. I'm not sure if all the hardware is in place for accuboom.

The accuboom node is there it wasn't detected with the switch on, the engine had to be running. I had 10-12 satellites showing on both the FM 750 and the Envizio. The Envizio is not showing DGPS. The NMEA settings are, GSA 10hz, GSV(?) 10hz, ZDA 5hz. Baud rate 19200.

Is DGPS needed for accuboom ?

 

[cumminsman1991]

Your NEMA Settings are the problem. Turn off GSV and GSA and turn on GGA and VTG both a 10Hz. Also change ZDA to 1Hz. This will fix your DGPS issue. DGPS is needed for AccuBoom operation.

 

[Bwing96]

raven

I took the settings and put them in the FM 750 and still getting the same results.
I'm not sure the raven is set up right.

 

[f_armer]

Is it just me, or why didnt they just add smartraxx to the envizio? Seems a lot less complicated way to do it. Is there a reason they did it this way?

 

[cdnredneck_t3]

Is it just me, or why didnt they just add smartraxx to the envizio? Seems a lot less complicated way to do it. Is there a reason they did it this way?

I am wondering the same thing. I thought the 750 is also capable of swath control, rate control and boom height. Why run 2?

 

[Bwing96]

Ag372 reciever

Can you run an Intellivew II out of Port A and a Raven Envizio Pro out of Port B at the same time?