The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I hooked an ez steer 500 up to my 250 it was a used unit from a neighbor when I turn on the ex guide it detects an ex steer I check ok I won't drive it on the road and then it says fault occurred with T2 un plug lighter plug restart...I have it hardwired any help?? I'm finding that my dealer is less than knowledgeable
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Correctly mounted. Talked to a tech from ag leader he said wiring or low voltage...had a suspicious wire going from guide to t2 so I ordered new one see if that solves my issue. Thank you for responding with positive thoughts and ideas
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top