The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
hi, we have an f2 that we are getting ready for soybean harvest. we bought this from a friend and this is our first season operating this machine. I decided to zero the cylinder, but when the cylinder bar is touching the #2 concave bar, the pointers are about 1/4 to 3/8 inch below zero on the gauges, even with the gauges slid all the way down. any suggestions on why this would be? the cylinder bars appear to be in pretty fair condition but I don't have anything to compare them to...thanks
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top