I used blue and still had one come out. I use the red all the time now. If you use the blue apply liberally, good luck.
F2 Feeder Beater Fingers
I am new to the Forum so hello everyone !
I am rebuilding the feeder beater on my F-2 and I am ready to install the new fingers.
Should I use the Red Loctite or the blue ?
I would prefer to use the blue in case you bend or break one you can get them out without heat which wrecks the plastic bushings/bearings.
What do you guys use ?
Thank you
I am rebuilding the feeder beater on my F-2 and I am ready to install the new fingers.
Should I use the Red Loctite or the blue ?
I would prefer to use the blue in case you bend or break one you can get them out without heat which wrecks the plastic bushings/bearings.
What do you guys use ?
Thank you
1 - 1 of 4 Posts
1 - 1 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Combine Forum
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
