The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Is there good and bad chain for feeder house do you need to replace bars they look alright is there anything wrong just replacing the chain at this time 2366 CASE 2002 done 950hours.
can you put bars on new chain are there any pitfalls in doing so.
will replace sprockets and bearings,can plates where sprockets are be build up, they are not worn badly.
 

·
Registered
Joined
·
998 Posts
If you just want to replace chain, there is no issue swapping the bars over. It is a lot cheaper option if the bars are ok and not bent badly.

Cut off plates for sprockets can be built up - do it all the time.

Good to hear you are doing sprockets and bearings too. Remember to put the debris auger(spacer) back in the correct way so it augers debris away from the bearing - not into it
 
1 - 2 of 2 Posts
Top