The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Assistance needed on how to set the rate for wheat on a
2320 flexicoil tank single shoot. It is hooked to a 6 primary run with a 54 disc 7 inch spacing case 8600 double disc tool bar. 30.916 ft drill width.
am assuming that cranking out and weighing will help get close- but how do i figure out how many revolutions.
Also any idea on how to set monitor.
My drive socket is 32, and the top is 40, but i cant calculate .
Thanks in advance, not sure quite where to start.
 
1 - 1 of 1 Posts
Top