Flexicoil blockage systems

5974 Views 7 Replies 5 Participants Last post by RunninREDharD, Feb 17, 2015

Patriot 4430

Discussion Starter · Feb 16, 2015

Hi guys, was just wondering if anyone has experience with flexicoil optical blockage, I got a case atx 700 and it has full blockage on the seed shoots, but seems I'm having some sensor issues and I would like to just run one sensor per tower to simplify the system for me, and at 150 bucks a pop the sensors would add up, so does anyone know if I would be best to just unplug the non required sensors and use the current 3 flow modules and gateway module or would I be better off to remove flow modules and run off the gateway only, as in the books diagram for a basic blockege system? Thanks a lot for any replies!

Save

1 - 2 of 8 Posts

Don Boles

· #2 · Feb 16, 2015

I had an all run system as you describe, it was crap giving bogus readings until we ground the sensors to the gateways and ground the gateways to the frame.
Dealer closed today, I'll see if I can dig up more tomorrow if you need, perhaps there is a bulletin on it.

Save

Don Boles

· #7 · Feb 17, 2015

You're welcome.
No, I was talking Linden Agri Center but you are correct, Georges' is the place to talk Flexi-Coil, I doubt there is another dealer on the planet that has moved as much Coil iron as Georges has.

Save

1 - 2 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month