The Combine Forum banner

Gleaner 7000 rigid to MF Rotary 8780xp

745 Views 5 Replies 4 Participants Last post by  cumminsisb
Came across an Gleaner 2005 yr auger header but according to the serial number it was born for R series Gleaner combine.
Looks like it should fit on the MF feeder house but I notice in the parts book there are different table augers between c62/ R series/axial combines?
What all is different with the auger?
Can this even be done easily?
1 - 1 of 6 Posts
I believe you will find that the Throat opening will have a filler plate on the left side, and the auger flighting is "offset" to the right. Remove some flighting from the long side and remove the filler plate and its close to back to "normal".
1 - 1 of 6 Posts