The Combine Forum banner
1 - 2 of 2 Posts

· Registered
300 Posts
Discussion Starter · #2 ·
Assuming there are none out there, I'm going to try and fabricate them. Everything else is going to be new in my feederhouse. These being wear parts I think they might as well be too.

2 Questions- Does any one know whether they would be made out of mild steel or hardened somewhat?

Current ones I have (the top ones (about 1.5" wide)) have grooves in them where the chain links run. I'm assuming these are worn areas and new ones should be flat (no grooves).

Anyone have any thoughts.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.