The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
361 Posts
REMOVE brush holder and outer linkage for vs drive belt and outer sheave will pull off - remove the three bolts that hold inner fixed sheave and locate and clean the three threaded holes in sheave - insert bolts and push the sheave off its hub - remove hub - wires are in a metal shield in groove in shaft - it lifts / pry it out.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top