The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I have an L3 that the tattletale is beeping constantly, however there are no warning lights lit up. When the "test" button is pushed the only warning lights that come on are in module II. Have determined that problem is tied to module IV, I think, because beeping quits when that module is unplugged. Module has power to it.

Where do I go from here?
 

·
Registered
Joined
·
168 Posts
Most likely the bulb is burnt out in that module so it is still beeping but not showing what is wrong.
 

·
Registered
Joined
·
188 Posts
When the test button is pushed any and all working bulbs should light up. It sounds like only one of your tattletale boxes is working. Then again on the R's I know the header clutch switch has to be on to allow the bulbs to come on when the test button is pushed. I would make sure all bulbs are working before chasing anything else first
 

·
Registered
Joined
·
1,276 Posts
Check all fuses. Been awhile but I believe it is the pacer fuse that also feed a wire on one of the modules witch will keep the alarm on
 
1 - 4 of 4 Posts
Top