The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,966 Posts
Discussion Starter · #1 ·
We moved our Envisio pro to a different tractor and not not getting a signal to the Envisio Pro anymore. Previously EP was used to run the Nh3 for seeding, it was getting the signal from a Pro 700. New tractor has a Trimble 750 and am trying to send the signal to the EP but am not getting GPS signal. I did swap the antenna from a Trimble to a Raven and am getting the satellites on the Trimble 750. What am I missing?
 

·
Registered
Joined
·
406 Posts
Are you using a 9 pin serial cable from the 750 to the Envizio? If so you might need a null cable or adaptor instead of a straight cable. I haven't dealt with a 750 before but the 500 typically required the null cable.

or/and

Is the 750 setup to export gps signal? I don't know the setup menus to tell you how to check for sure but somewhere in the gps setup there should be settings to export GGA and VTG.
 
1 - 4 of 4 Posts
Top