The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,
Has anyone used a John Deere system (2630 and SF3000) to steer and collect yield info on a New Holland CR combine? I understand that Deere's autotrac controller can be used on New Holland and Case tractors but I don't see any combines listed as being 'approved'? Is there a different yield sensor I can install to work with the 2630? Our combine ('11 CR6090) is guidance ready and would like to use our existing JD system on it. Thanks in advance for your help!
 

·
Registered
Joined
·
7 Posts
I use 2630 this year use atu 200 and feed gps to the new holland screen for yield mapping I think will not yield map on 2630 but I think u could get 2630 to steer with right person john deere and new Holland did not help much to set it up
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top