The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Does someone know how its possible that the gs3 program is gone from my commandcenter? I know that when i plug my 2630 screen the gs3 switch over to the 2630 but when i plugged out my 2630 to put on another machine, i can't get the gs3 back on the commandcenter.
Maybe someone has the same?
 

·
Registered
Joined
·
88 Posts
Hit the menu button then display(G), hit Settings(J), hit Multiple(H) now if you see a button on the bottom of the screen that says "Restore Factory Default Settings" hit that button then cycle power and it should bring your GS3 back. If you don't see that button or you have already done this shut the tractor off and let it sit 15-20 min then restart it should come back the key is patience. Sometimes it comes back right away after cycling the key other times I've had to wait for some time
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top