The Combine Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
293 Posts
Does anyone have any tricks, traps and comment on harvesting peas with a STS combine and 630F.
630F: Calibrate header with the 3 height sensors down. Then lock up your 3 height sensors and then only use the float pressure on feeder house for height control. Lower your cutter bar flex pressure to about 1300 (make sure all rigid locks are removed under header) to allow cutter bar to drop and flex.
 

·
Registered
Joined
·
144 Posts
Round bar or large wire concaves, remove separator grates, upper sieve around 18, lower 8-11, wind depends on which sts, 70 series around 800, rotor range from 270 to 400 (low as you can), concave 20 to 30 (book says 15 to 25)
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #5 ·
Thanks. Will try those especially the patience part. We are only due to harvest in November but I have never done peas before.
 
1 - 6 of 6 Posts
Top