The Combine Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
352 Posts
Discussion Starter #1
i was wondering if anybody had a good picture of the headsite wands for header height on a 900 or a 600 ridgid head
 

·
Registered
Joined
·
139 Posts
Deere has them available for all 600 series flex and rigid, just a thought, we sell both, have a few people that use them on 635f's for small grain. Headsight sensors bolt inplace of three skid plates on the flex platform, on ridgid I belive they bolt to the gaurd mounts as well as the 900 rigid???if I'm wrong someone can correct me.deerefever.
 

·
Registered
Joined
·
352 Posts
Discussion Starter #7
ya if you want to i think they want to put some on a draper head to so that would be helpfull also.
 

·
Registered
Joined
·
14 Posts
Stevenwoll. The header height on your 936D, does it affect how low to the ground u can go for like peas or soybeans? Do the mounting brackets dig into the dirt if u run to close to the ground? The headsite controls tie right into the contour master on the conbine right? Thanks
 
1 - 9 of 9 Posts
Top