The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
We have a 42 foot honey bee draper front that has developed an allmighty frowning sag. Not sure if it's the actual main beam sagging or just the cutter bar edge. Any suggestions on how to fix this?
 

·
Ooohhh Deere
Joined
·
1,975 Posts
Not much you can without cutting and welding. I put a tie rod setup up over our old 42HB to keep it straight. Will post a pic tomorrow if you like.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
Yeah I think cutting and welding is the only remedy, or anchoring middle of front then chaining each end upwards, this may counter bend front. It's going to be a bit of trial and error I think!!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top