The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I recently picked up a 36' honey bee for my A 86. It was last on a 9790 Massey. My problem is the reel doesn't turn when I engage the header. I already checked to make sure the reel speed is set to manual. I put a single point hookup on the header. Is there a sensor that my pickup has and the draper header doesn't? The pickup header works fine, so I know I have oil flow.
 

·
Registered
Joined
·
158 Posts
If it is like the r series there is two pins the header jumps in the plug to tell it to run the reel. I made a set of pig tails to run a non single point hookup head and have to jump the two pins to get my pickup belts to turn. Don't remember what numbers but was able to trace down in wiring schematic in owners manual.
 

·
Registered
Joined
·
94 Posts
From what I can remember you have to change the reel speed sensor from 2 wire to a 3 wire system. This I believe changed when the combine went to more functional control on the color terminal
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top