The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I had to replace horizontal unloading auger tube being that my dad hit a pole with it. When I took the auger out I made a mark on the outside of it so I new the position where it had to go back in. When I was reinstalling it, I noticed the section closest to the combine was pulled off its shaft. How do I tell where its got to go or timed? If that one is different then I assume the next section will be off? Is there any online lit. that could help me. I have a 1992 John deere 9500. Thank you much
 

·
Registered
Joined
·
434 Posts
The section at the elbow is installed 90 deg following the vertical auger. The two horizontal sections are at 180 deg apart.
 
1 - 2 of 2 Posts
Top