The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
131 Posts
I will take a stab at it a lot more qualified people here to comment on it, but these are the things we have either done or are planning to get done.
Lower rear of front feeder. Move top feeder chain drive shaft forward 1.5". Install bison rotor. Smaller chopper drum,this may already be standard now. Making sure header fronts are feeding the broad elevators correctly. I think these would be the most needy to make the machines run in all conditions better. Altering speeds on clean grain elevator and covers to cut wear on accelerator rollers are other things people are working on. There are probably a lot of other fine tuning things which I would be keen to note.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top