The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
54 Posts
I can't get the bearing/flange off of the shaft. When it comes off, I can easily unbolt the shaft from the factory cylinder.
Generally they are a tapered setup try putting nut back on a few turns so you don't damage thread,use correct size pipe over shaft and a few sharp taps should free it up, you will understand once it comes apart, generally easier still in the machine though
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top