[Ehughes2020]

Howdy,

I wanted to know what length Hydraulic lines should be from the cylinder on an implement to my rear remotes? I do not want to short myself. I appreciate your responses.

Erik

 

[oldguy48]

Howdy,

I wanted to know what length Hydraulic lines should be from the cylinder on an implement to my rear remotes? I do not want to short myself. I appreciate your responses.

Erik

It is called a tape measure plus room for turning & slack.

 

[Ehughes2020]

Well I'm dealing with COVID brain fog and wanted to know if there was a general length people were using, so tape it is.

 

[LRNuske]

Old guy is right every implement is different so length of hydraulic lines are going to be different for every machine. So a general rule is impossible to make. Also some
Implements have no folds or pivots other have multiple fold points and pivots. Make sure to give the lines plenty of slack around implement folds and connection points so whatever you measure add a couple feet for every fold and connection to make sure nothing fouls.

 

[Ehughes2020]

Got it, thank you

 

[white owl]

GENERALLY THE SLACK IS 4 FEET PAST HITCH PIN ON IMPLEMENT.