[460]

CTS Hydraulic light coming on. It seem like it's building up pressure in the valve body and not bypassing. If we shut it off and start it up no noise in electro over hydraulic body. Then if you hit any hydraulic function and release it still sounds like your holding a button. Checked the limit switch on auger but that seems to cut out when you swing auger back.
Any suggestions this is slowing us down and not sure where to start.

 

[460]

Thanks, there was a spring broke in the relief valve body, I think we solved the heat issue. But the reel won't go down unless you shut the combine off. We got the parts late so will look at reel valve body in the morning.

 

[460]

Not overheating now. but reel still won't go down once the oil gets hot. We're doing lentils now so the reel is running right down all the time. We were hoping to get caught up so we good do some more troubleshooting. I will check the o-ring. Thank you very much more the info.

 

[460]

Pulled poppet out behind plug, we found 1/3 of 0-ring gone. Problem solved. We had inspected poppet beforehand but didn't check that o-ring. Thank you, ststech.