[casefarmer]

I know this belongs somewhere else on the site but i also know this is where everyone looks.. so can you leave this here for 2 days then move it??? (thanks)

I really need a GPS antenna reciever with 2 ports

I don't care if its the old model two piece or the new all in one.

HELP!!!!!!!!

 

[mx270a]

What level of precision do you require, and how much are you looking to spend?

You could buy two of the cheap $100 receivers and put them next to each other, but accuracy is going to be low. This would be for a yield map or something.

I know the Trimble 252 has two ports built in. Either port can do CanBus or Serial. However, you're looking at $3K for just WAAS, or $5K for one that will do Omnistar.

Technically, I think you can split the send conductor of a serial line into a Y connection going to two devices. The receive connection would have to go to one of the two devices. GPS receivers don't really need to get any data back other than when updating firmware or settings.

-Lance

 

[casefarmer]

Yeah i need just 6-8 inch really.

also the light bar i usually run the rate up kinda high and my dell pda with farmworks at a lower rate...

 

[panther1400]

Do you have a picture or model # of what you are looking for, I have a receiver out of my 2188 AFS system.

 

[casefarmer]

I think its the AGgps 321 or something

i need the antenna as well.

also it will have 2 ports on it.

port A and Port b

if you have all of the above make an offer i need it soon

 

[panther1400]

My receiver has two ports but I don't know if I want to get rid of my antenna but maybe, make an offer.