The Combine Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Is it possible to make the 1020 ahc work with the 3 position ahc on an L3? After this fall I'm fed up with my 320. Was looking at 920 deere, but there is a nice 1020 close by for a good price. Any help greatly appreciated. Thanks
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #2 ·
Concerning the above, could the spring sensor on the end of the 320 be mounted in place of the potentiometer on the 1020? It seems it would just be a matter of getting the right geometry on the linkage. Any thoughts if this would work?Thanks for any thoughts.
 

·
Registered
Joined
·
1,553 Posts
I answered your PM about the "right" way to do this.....but if you want to make a simple switch assembly, for a single height, all you would need are 2 limit switches.
 
1 - 7 of 7 Posts
Top