The Combine Forum banner
1 - 1 of 1 Posts

· Registered
16 Posts
Discussion Starter · #1 ·
Was just wondering if anyone had any experience on running a 1610 flexicoil air cart with an older tractor with open center hydraulics (IH 4386). Drill would be a 40 footer on 12 inch spacing. Was planning on upgrading tractors for next year as well as the drill but its a bit of a big bite at this time. Also i am not wanting to put a $8000 atom jet kit on the old beast as i hope to get into a newer tractor in the next few year. Any chance this could be done effectively? Thanks in advance for the replies.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.