The Combine Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
120 Posts
Discussion Starter · #1 ·
I tried looking back through the post but cant remember where to look. a month or so ago there was discussion about using the integra in place of the C2100. I was told i need to replace my load sensor and moisture sensors with agleader. The part that i am missing is who i need to call to get the wiring pigtail to put from combine to the integra.
 

·
Premium Member
Joined
·
120 Posts
Discussion Starter · #4 ·
greencountry

ok so you plug into the harness and not the monitor. does that particular plug have an identification? I havent looked at the harness yet but will look shortly. So did you eliminate your fieldstar all together then.
 

·
Premium Member
Joined
·
120 Posts
Discussion Starter · #5 ·
redline

the three part numbers you need to use the integra for yield mapping are:
4100370 combine kit $2350
4100413 elevator mount kit $500
4001215 moisture sensor $450

this is straight from the guy i talked to at agleader yesterday. This however doesn't give any other functions to the integra and still need to use the C2100 to run the combine.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top